VS:OffsetPoly: Difference between revisions
Jump to navigation
Jump to search
m (1 revision) |
m (Transfer Orso to _c_) |
||
(One intermediate revision by the same user not shown) | |||
Line 60: | Line 60: | ||
----------------------------------------------------------------------------------------------------------- | ----------------------------------------------------------------------------------------------------------- | ||
<remark></remark> | <remark> | ||
([[User:CBM-c-|_c_]], 2011): The routine was introduced undocumented by VW10 (2005), then made public by VW17 (2012). | |||
OffsetPoly fails: | |||
* on holes, they are ignored | |||
* when by an offset less than 1 unit: it copies in place, instead of offsetting (tested from VW 2011 through 2014). For example: | |||
:* Units meter, offset 1m > succeeds | |||
:* Units meter, offset 0.9m > fails | |||
:* Units cm, offset 1cm > succeeds | |||
:* Units cm, offset 0.9cm > fails | |||
</remark> | |||
----------------------------------------------------------------------------------------------------------- | ----------------------------------------------------------------------------------------------------------- | ||
Line 66: | Line 76: | ||
----------------------------------------------------------------------------------------------------------- | ----------------------------------------------------------------------------------------------------------- | ||
<seeAlso></seeAlso> | <seeAlso> | ||
Similar calls: | |||
* [[VS:OffsetPolyN]] | |||
* [[VS:OffsetHandle]] | |||
</seeAlso> | |||
----------------------------------------------------------------------------------------------------------- | ----------------------------------------------------------------------------------------------------------- | ||
<version> | <version> | ||
Availability: from Vectorworks | Availability: from Vectorworks 2012 | ||
</version> | </version> |
Latest revision as of 05:29, 30 December 2020
.VectorScript|VectorScript ..VS:Function Reference|Function Reference ..VS:Function_Reference_Appendix|Appendix
Description
Offsets a polygon or polyline. Must handle open & closed polys. A positive distance offsets to the outside; negative to the inside. Should remove self-intersecting segments from the result. Should support "smooth" vs. "sharp" offsets.
FUNCTION OffsetPoly(
h :HANDLE;
offsetDistance :REAL;
numberOfOffsets :INTEGER;
consolidateVertices :BOOLEAN;
sharpCorners :BOOLEAN;
conversionRes :INTEGER;
consolidationTolerance :REAL) : HANDLE;
def vs.OffsetPoly(h, offsetDistance, numberOfOffsets, consolidateVertices, sharpCorners, conversionRes, consolidationTolerance): return HANDLE
Parameters
h HANDLE offsetDistance REAL numberOfOffsets INTEGER consolidateVertices BOOLEAN sharpCorners BOOLEAN conversionRes INTEGER consolidationTolerance REAL
Remarks
(_c_, 2011): The routine was introduced undocumented by VW10 (2005), then made public by VW17 (2012).
OffsetPoly fails:
- on holes, they are ignored
- when by an offset less than 1 unit: it copies in place, instead of offsetting (tested from VW 2011 through 2014). For example:
- Units meter, offset 1m > succeeds
- Units meter, offset 0.9m > fails
- Units cm, offset 1cm > succeeds
- Units cm, offset 0.9cm > fails
Version
Availability: from Vectorworks 2012
See Also
Similar calls:
Similar calls:
- [[VS:OffsetPolyN]]
- [[VS:OffsetHandle]]